4/19/2021 0 Comments Windows 95 Floppy Image
Press 1 for the Create DOS partition or Logical DOS drive option followed by Enter.Again Ill be using Oracle VirtualBox 5.1.4.While it can be made to work in a useable state, it wasnt offered the same support to the likes of Windows NT 4.0 or 2000.
![]() Pentium 100 with 16MB RAM) to be fairly sluggish in comparison. A Create Virtual Machine dialog box will appear allowing you to select which operating system it will be using for this virtual machine (VM). You may either select the Windows version as shown below, or type Windows 95 and the drop-down selection will automatically change. By default as Windows 95 had been selected, the recommended memory size is 64 MB. Windows 95 will run on the lowest option of 4 MB, though wont be satisfactory. A historically accurate amount was typically in the range of 8 MB to 32 MB. As we dont have one yet, we will select the Create a virtual hard disk now option and choose Create. Again as weve chosen Windows 95, VirtualBox has suggested the recommended size of the hard disk to be 2 GB. Select VDI (VirtualBox Disk Image) and Dynamically allocated over the following couple of options before choosing the size of the hard disk. If you are using the OSR 2 or later release you may increase above this as these support the FAT32 file system. Again as Im using OSR 2.1 Im going to increase it to 6.4 GB, an accurate size for a physical hard disk in the late 1990s. Windows 95 Floppy Image Driver Is LoadedBy default when the CD-ROM driver is loaded, its designated as Drive R. I suspect this is just to avoid any issues if someone decides to create or has multiple partitions on their hard disk. This is because during installation the floppy boot disk is no longer required and will boot from the hard disk instead once most of the files are installed. When this occurs, Setup is still expecting to find additional files on Drive R and although you can change the path to search for the required files elsewhere, it wont let you access the CD as the driver for the CD-ROM wasnt loaded. Setup can still be completed, though this has the likelihood of causing missing file errors during Windows start-up or Device Manager in Windows showing issues afterwards. That way, the final stage of Setup can then still access the CAB files it is requesting to extract the required files for installation without trouble. This creates a directory (folder) named win95 on the hard disk. Then type copy r:win95.cab c:win95 to copy the main installation files from the CD to the new directory on your hard disk. At this stage typing c: at the command prompt will bring up an error invalid drive specification, meaning basically that the hard disk has not been designated as Drive C and is completely bare. FDISK essentially is a DOS utility to configure hard disk partitions. The FDISK utility comes up and as the hard disk earlier was specified as 6.4 GB in size, the first query is whether to enable large disk support. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |